6709 Ritchie Hwy, Glen Burnie, MD 21061Fence repair specialists serving a 20-mile radiusCall (443) 292-6998
Wood fence leaning over a post rotted at grade, a common repair on older Lansdowne, MD lots
Lansdowne, MD · Baltimore County

Fence Repair in Lansdowne, MD

Lansdowne is a Baltimore County community of small, older lots around Hammonds Ferry Road, and chain link is the fence you see on almost every block. Our Glen Burnie crew repairs leaning corner posts, torn fabric, dragging gates and worn wood sections here, and replaces, installs and stains fences when a run is finished.

  • Fence repair specialists
  • ~4 miles from our Glen Burnie shop
  • Wood · Vinyl · Aluminum · Chain link

How a Chain Link Fence Actually Holds Together

Chain link is the backbone of Lansdowne backyards, and most of it has been up a long time. Knowing how it is built makes it easier to see what is failing. The fabric, the woven wire mesh, is stretched tight between terminal posts: the heavier posts at corners, ends and gates. Line posts in between only hold the fabric up. A top rail runs across the posts, and tension bars threaded through the fabric are clamped to the terminal posts with tension bands.

That means a chain link fence is only as tight as its terminal posts. When one of them moves, the whole run goes slack, the fabric bellies out, and the top rail starts to bow between line posts.

Because the parts are standard, most of a chain link fence can be repaired piece by piece. A bent rail, a broken band, a loose tie or a stretched section of fabric each gets swapped individually, and the sound parts stay. That is why we take a close look before anyone talks about replacing an old run.

Corner and End Posts That Pull Over

The most common chain link repair in Lansdowne is a corner or end post leaning in toward the fence. Terminal posts carry the pull of the stretched fabric all the time. If the footing was shallow, or the post has rusted thin at the ground, that constant pull tips it over a little more each year.

Many older fences were built without a brace rail and truss rod at the corners. A brace rail runs from the terminal post to the first line post, and the truss rod runs diagonally back, so the pull is shared between two posts instead of one. Without them, the corner post fights the fabric alone.

To fix it, we release the tension, dig out the old footing, and set the terminal post plumb in a deeper concrete footing. Then we add a brace rail and truss rod, rehang the tension bar and bands, and stretch the fabric tight again. Once the corner stops moving, the sag in the rest of the run usually comes out with it.

Galvanized chain link fence with properly set terminal posts and a walk gate, the corner repair we make on Lansdowne, MD fences

Torn or Stretched Fabric and Splicing In New Mesh

Chain link fabric gets torn by a falling limb, pushed out by a dog that leans on the same spot every day, or bent by a kid climbing over. On small Lansdowne lots, where the fence sits close to driveways and alleys, it also gets clipped by cars and trash cans.

A torn or stretched section does not mean new fabric for the whole run. Chain link is woven from a series of zigzag wires, and a single wire can be spun out of the mesh to cut away the damaged piece. A new piece is then woven in with a matching wire, so the patch becomes part of the same fabric.

The key is matching. Older fences in Lansdowne come in different mesh sizes and wire thicknesses, and a patch that does not match will not weave in cleanly. We measure the diamond size and wire gauge before cutting anything. After splicing, we retie the fabric to the posts and rail and stretch it tight so the patch lies flat with the rest of the fence.

Chain Link Gates That Drag and Will Not Latch

Chain link gates in Lansdowne take the most use of any part of the fence, and they fail in a few predictable ways. The gate drops at the latch side and drags on the walk. The latch fork no longer reaches the post. The frame twists out of square.

Usually the gate is fine and the post is the problem. A gate post that has leaned an inch at the top drops the latch side much more than that. Hinges can also slip down the post as their bolts loosen, and older gate frames without a diagonal brace sag under their own weight over time.

We start by plumbing or resetting the gate post, then raise and tighten the hinges, square the frame and add a brace if it needs one. The latch gets adjusted or replaced so it catches cleanly. For any gate that still will not close right, The Fence Repair Guys of Glen Burnie can rebuild the frame on new hinges.

Wood Sections on Small Lansdowne Lots

Not every Lansdowne fence is chain link. Many owners have added a short run of wood privacy fence along a patio, a back line or the side facing a neighbor, often tied into the existing chain link. On a small lot, those wood sections take a specific kind of wear.

String trimmers do much of it. On a tight yard, the trimmer runs along the base of the fence every week, and the line chews into the bottom of wood posts and pickets right at the soil line, which is exactly where rot starts. Once the surface is torn, water soaks in and the post softens from the outside.

We replace chewed and rotted pickets to match, replace soft posts, and can lay a strip of mulch or gravel along the base so the trimmer stays back. Where wood meets chain link, we use a proper post that can carry both. On wood that is still sound but gray, a penetrating stain slows the water that drives rot.

Gray weathered wood fence with smashed pickets and a hole, the kind of wood section repair we do on small Lansdowne, MD lots

Lansdowne Streets and Nearby Areas We Cover

Our Glen Burnie crew covers Lansdowne from the streets along Hammonds Ferry Road to the blocks near Washington Boulevard and I-695, including the neighborhoods toward Baltimore Highlands. Lansdowne is in Baltimore County, so we confirm permit and HOA requirements for your address before work starts, and we call Miss Utility before digging any post hole.

Most of our Lansdowne work is chain link: corner posts pulled over by the fabric, sagging top rail, torn mesh, and gates that drag or will not latch. The rest is short wood sections with trimmer damage and rot at the soil line, plus older runs where it finally makes sense to replace the whole line with new galvanized chain link, black vinyl-coated chain link, vinyl or wood.

We also work in nearby Arbutus, and The Fence Repair Guys of Glen Burnie covers Halethorpe next door with the same approach: repair what is sound, replace what is not. For your own fence, The Fence Repair Guys of Glen Burnie will show you which parts we would keep.

Nearby, Arbutus is served by The Fence Repair Guys of Glen Burnie, and Elkridge is too, through The Fence Repair Guys of Glen Burnie.

Nearby

Other towns we serve near Lansdowne

5 mi from our Glen Burnie shop

Fence Repair in Halethorpe

Halethorpe, MD fence repair for older single-family homes near I-95, I-695 and the MARC station. Garage-end posts, sagging rails, rusted steel railings.

Halethorpe fence services
6 mi from our Glen Burnie shop

Fence Repair in Arbutus

Arbutus, MD fence repair near UMBC, Sulphur Spring Rd and East Dr. Fences on brick homes and retaining walls, painted pickets, overgrown hedges, staining.

Arbutus fence services
3 mi from our Glen Burnie shop

Fence Repair in Brooklyn Park

Brooklyn Park, MD fence repair for old wood and chain link on compact lots near the city line. Vines, slats, car strikes, gates, replacement and staining.

Brooklyn Park fence services
2 mi from our Glen Burnie shop

Fence Repair in Linthicum

Linthicum Heights fence repair for older yards under big trees. Root-lifted posts, mossy boards, picket fences, gates, limb damage, replacement and staining.

Linthicum fence services
5 mi from our Glen Burnie shop

Fence Repair in Elkridge

Fence repair in Elkridge, MD for steep wooded lots near Patapsco Valley State Park and HOA homes off Route 1, Route 100 and Montgomery Rd. Posts, gates, panels.

Elkridge fence services
7 mi from our Glen Burnie shop

Fence Repair in Baltimore

Baltimore, MD fence repair for rowhome rear yards in south and southwest Baltimore. Alley gates, shared party fences, wood and chain link, tight alley access.

Baltimore fence services
8 mi from our Glen Burnie shop

Fence Repair in Catonsville

Catonsville, MD fence repair for terraced yards with retaining walls, uphill gates, salt-worn front pickets, and road-front chain link off Frederick Rd.

Catonsville fence services
1 mi from our Glen Burnie shop

Fence Repair in Ferndale

Ferndale, MD fence repair for compact older lots off Crain Hwy and Ritchie Hwy. Frost-heaved posts, tight side gates, shared back lines, replacement, staining.

Ferndale fence services

See the full 20-mile service area

FAQ

Fence questions from Lansdowne homeowners

The corner post on my chain link fence in Lansdowne is leaning in. What causes that?

A corner post on a chain link fence in Lansdowne leans in because it carries the constant pull of the stretched fabric, and its footing or the steel at ground level has given way. Many older fences here were built with no brace rail or truss rod at the corners, so the corner post fights the fabric alone. Shallow footings and rust at the base make it worse. We release the tension, reset the post deeper in concrete, add a brace and truss rod, and restretch the fabric.

Can you patch a hole in my chain link fence in Lansdowne without replacing the whole roll?

Yes, a hole in a chain link fence in Lansdowne can be patched without replacing the whole roll by splicing in a new piece of fabric. Chain link is woven from zigzag wires, so we spin one wire out to remove the damaged section and weave a new piece in with a matching wire. The patch has to match the old mesh size and wire gauge, so we measure both first. Then we retie the fabric and stretch it tight so the patch lies flat.

My chain link gate in Lansdowne drags on the ground. Can it be adjusted?

Yes, a chain link gate in Lansdowne that drags on the ground can usually be adjusted, and the fix often starts with the gate post, not the gate. A gate post that leans slightly at the top drops the latch side much more. We plumb or reset the post, raise and tighten the hinges that have slipped down, and square the frame with a brace if it has twisted. Then the latch is adjusted so it catches cleanly. A bent frame gets replaced.

Should I replace old chain link in Lansdowne with new chain link or something else?

Replacing old chain link in Lansdowne with new galvanized chain link makes sense if you still want an open, low-upkeep fence that takes little room on a small lot. If you want privacy, wood or white vinyl blocks the view but takes slightly more width and, for wood, staining. Black vinyl-coated chain link is a middle option: it has the same strength and footprint, but it looks cleaner against a lawn. We walk the line with you and match the material to what the fence needs to do.

My Lansdowne chain link fence has no top rail and sags between posts. Can you add one?

Yes, a top rail can usually be added to a Lansdowne chain link fence that has none, as long as the posts are sound and the correct size to take the fittings. Older fences sometimes used only a top tension wire, which stretches over time and lets the fabric sag between posts. We fit rail end cups and loop caps onto the posts, run the top rail across, and tie the fabric to it so it stays level. Leaning posts get reset first.

Can black vinyl-coated chain link be added to my older Lansdowne fence?

Black vinyl-coated chain link fabric can be added to an older Lansdowne fence, but on its own it will hang against silver galvanized posts and rails, so most owners replace the posts, rail and fittings with black-coated parts too. Mixing coated fabric with bare frame works mechanically but looks patched. If your posts are still solid, we can tell you whether keeping them and switching only the fabric makes sense for that run, or whether replacing the full frame gives a cleaner result.

My string trimmer has chewed up the bottom of my Lansdowne fence posts. Is that a problem?

Yes, string trimmer damage at the bottom of Lansdowne fence posts is a real problem on wood, because it tears the surface right at the soil line where rot starts. Once the wood fibers are torn, water soaks in and the post softens from the outside in. On vinyl, trimmer line scars the surface and can crack it in cold weather. We replace badly chewed posts and pickets, and a strip of mulch or gravel along the base keeps the trimmer back.

Why does my chain link fence in Lansdowne rattle and bang in the wind?

A chain link fence in Lansdowne rattles and bangs in the wind because its fabric is loose: ties have broken, tension bands have slipped, or a terminal post has leaned and let the tension go. Loose fabric slaps against the posts and rail with every gust, and that movement wears through more ties. We replace broken ties and bands, reset any leaning terminal post, and restretch the fabric. Tight chain link is quiet because the mesh cannot swing against the frame.

Do you repair fences around Hammonds Ferry Road in Lansdowne?

Yes, we repair fences around Hammonds Ferry Road in Lansdowne, along with the streets near Washington Boulevard and I-695 and the neighborhoods toward Baltimore Highlands. Lansdowne is a short run up the highway for the Glen Burnie crew, so we are in this corner of the county often. Most of our Lansdowne work is chain link: corner posts pulled over, sagging rail, torn mesh, and gates that drag. We also repair the short wood sections many owners have added for privacy, and we replace runs that are too rusted or bent to save.

My neighbor's chain link fence and mine are tied together in Lansdowne. Can you separate them?

Yes, two chain link fences tied together between Lansdowne neighbors can be separated or rebuilt into one shared fence, depending on what both owners want. On small lots, a newer fence was often wired onto an older one or hung from the same terminal post, so a problem in one pulls on the other. We find which posts carry which fabric, set a dedicated terminal post where the fences meet, and retension each run on its own. Both owners should agree before work starts.

Find us

The Fence Repair Guys of Glen Burnie

6709 Ritchie Hwy, Glen Burnie, MD 21061 · (443) 292-6998. Open in Google Maps →

Free estimates

Fence leaning, broken, or down? Let’s get it standing straight.

Call or send a request and we’ll set up a time to look at the fence in person, figure out what actually failed, and tell you straight whether it needs a repair, a rebuild of one section, or a full replacement.

(443) 292-6998
The Fence Repair Guys of Glen Burnie
6709 Ritchie Hwy, Glen Burnie, MD 21061
Serving Glen Burnie, Baltimore, and a 20-mile radius

Request a free estimate

Tell us what’s going on with your fence. Photos help, and you can text them after we call you back.

Call NowFree Estimate